6 Year Tank & Parts Warranty
1 Year Service Labor Warranty
Diameter 26 Height 62 3/4 (Top of Vent)
Pre-Approval Takes Only Minutes!
For Informational Purposes only
Delivery of New Water Heater
Free Drain Pan
Haul Away & Recycling of Old Tank
New Water Heater Start-Up
New Connectors for Gas / Water / Vent
Gas Piping Inspection / Leak Check
3-Year Warranty On Installed Plumbing
Installation In Same Location
Permit Processing if Required
Bradford White ICON System - Intelligent gas control with proven millivolt-powered technology and built-in piezo igniter. A standard, off-the-shelf thermopile converts heat energy from the pilot flame into electrical energy to operate the gas valve and microprocessor. No need for external electricity.
Enhanced Performance - Proprietary algorithms provide enhanced First Hour Delivery ratings and tighter temperature differentials.
Advanced Temperature Control System - The microprocessor monitors and controls burner operation to maintain consistent and accurate water temperature levels.
Intelligent Diagnostics - An exclusive green LED light prompts the installer during start-up and provides ten different diagnostic codes to assist in troubleshooting.
Pilot On Indication - Flashing green LED provides a positive indication that the pilot is on.
Separate Immersed Thermowell - High-strength advanced polymer composite thermowell isolates electric temperature sensor and surrounding water. No need to drain the tank when removing gas valve.
Factory Installed Hydrojet 2 Total Performance System - Cold water inlet sediment reducing device helps prevent sediment build up in tank and increases first hour delivery of hot water.
Vitraglas® Lining - Bradford White tanks are lined with a exclusively engineered enamel formula that provides superior protection from the highly corrosive effects of hot water. This formula (Vitraglas®) is fused to the steel surface by firing at a temperature of over 1600ºF.
Side Connections - 3/4" NPT tappings that allow easy connections for space heating applications (potable water only).
Non-CFC Foam Insulation - Covers the sides and top of tank, reducing the amount of heat loss. This results in less energy consumption, improved operation efficiencies and jacket rigidity (M-I-75 has 1-1/4" and M-I-100T has 2").
Water Connections - Factory installed true dielectric fittings extend water heater life and eases installation.
Hand Hole Cleanout - Allows inspection of tank interior and facilitates the removal of sediment deposits (M-I-100T models only).
Protective Magnesium Anode Rod.
4" "Snap Lock" Draft Diverter.
T&P Relief Valve - Included.
Brass Drain Valve - Tamper proof design.
Intended Household: 5+ Person